Catalog pricing shown. Please Sign In to see your pricing.

Arcoaire HP Single Phase Split System Multi Stg 2.5 Ton 36k BTU AHU 15.5 SEER2

Arcoaire HP Single Phase Split System Multi Stg 2.5 Ton 36k BTU AHU 15.5 SEER2
Kit Includes whip 6' 3/4" 6GA, No Vent Caps, 3" Plastic Pad, Surge Protector, 50' Line Set 1/2" Insul, PVC Adapters/Fittings, 6" Heat Pump Riser, PVC Trap Kit, Furnace Leveler, 2H/2C Thermostat, Disconnect

This retail set contains

Vendor Name:
Arcoaire
URI Part Number:
Arcoaire HP Single Phase Split System Multi Stg 2.5 Ton 36k BTU AHU 15.5 SEER2
Shipping Weight (Lbs.):
200
Energy Star:
Not Energy Star Compliant
Includes:
DLCURAH30ABK, FMA4X3600AL, HPKIT41
Nominal Capacity (BTUH):
30000
Cooling Efficiency (EER2):
9
Cooling Efficiency (SEER2):
15.5
Heating Efficiency HSPF2:
8.5 HSPF2
System Indoor Type:
AHU
System Outdoor Type:
Multi Stage
System Coil Configuration:
Front Return
System AHU Type:
Specialty AHU (Uncased, Apartment)
System Nominal Tons:
2.5 Ton
AHRI System Number:
211222764
Heat Pump, Single Phase, Split AHU Multi Stage, Front Return DLCURAH/FMA4

Heat Pump Inverter
  • Utilize expansion device on the indoor unit
  • Insulate suction line only
  • Anti corrosion coating
  • Built in algorithm learns and adapts
  • Monitors suction pressure/temperature (super heat) to regulatecompressor speed
  • Field adjustable timer (ramps up to 100% if thermostat not satisfied)
  • Automatically ramps up/down 30-120% rated capacity
  • Field set sw 1-3 to A/C only
  • Low ambient cooling to -22°F
  • Pre charged for 25' tubing
Front Return Fan Coils
  • Factory installed TXV (4X) - Piston (4P)
  • EC motor (4X) - PSC Motor (4P)
  • Motor suspended on rubber grommets for quieter operation
  • Standard return air grille panel and is convertible to bottom return
  • Replaceable air filter factory supplied with all models
  • Fully insulated for conditioned space (not to be installed in unconditioned spaces)
  • Upflow application only
  • 208/230-1-60 supply voltage
  • Fresh air intake holes (capped from factory)
  • Units fits between standard stud spacing
  • All service access is located in the front
  • Primary and secondary drain connections exit from the bottom
  • No return-air ductwork required in specific applications